English
Precautions for the use of reducer of parallel shaft
When the reducer is working, check the temperature rise of the bearing and the oil sump, and the noise of the reducer at any time. If an abnormal situation is found, immediately stop the machine to find the cause, and restart the machine after troubleshooting. Regularly check the reducer Check the tooth surface of each internal gear. If there is a bit of corrosion, scratches, bonding, plastic deformation or even broken teeth on the tooth surface, stop using it and contact the relevant unit immediately, and the user should also take care of all failures. A detailed original record of the development process for the purpose of analyzing the cause of the failure.
For the reducer with spring base, the levelness, axial and radial swing of the reducer should be checked regularly, and the rigidity of the elastic shaft should be checked and measured once a year, and compared with the reference value during the test run, reducer of parallel shaft helical gear reduction To determine whether the elastic shaft is deformed, check the amplitude of the reducer regularly and compare it with the table below. Do not exceed the allowable value. Check the fatigue and deformation of the spring once a year and compare the results with the table below. The result of the check is found to be too large. When deforming, it should be replaced in time or the springs should be adjusted so that the hands of each spring are even.
For the reducer with spring base, the levelness, axial and radial swing of the reducer should be checked regularly, and the rigidity of the elastic shaft should be checked and measured once a year, and compared with the reference value during the test run, reducer of parallel shaft helical gear reduction To determine whether the elastic shaft is deformed, check the amplitude of the reducer regularly and compare it with the table below. Do not exceed the allowable value. Check the fatigue and deformation of the spring once a year and compare the results with the table below. The result of the check is found to be too large. When deforming, it should be replaced in time or the springs should be adjusted so that the hands of each spring are even.
